Separation of positional isomers by the use of coupled shape-selective stationary phase columns

The successful separation of 2- and 3-methyl-substituted positional isomers of butanol, butyl acetate, and butanoic acid and its ethyl ester, is reported. These compounds are of interest in the study of wine flavour, however the separation of the 2- and 3-methyl isomers may present problems, and more so in the presence of the wine matrix components, when single capillary column gas chromatography (GC) is used. The strategy to achieve separation was based on the use of shape-selective cyclodextrin derivative (CDD) capillary columns (commonly referred to as chiral columns). These columns provide simultaneous resolution of the enantiomeric pairs of the 2-methyl isomers, and at the same time the ability to separate the 3-methyl isomer from the 2-methyl is achieved in all but the case of the ( S)-2- and 3-methylbutanol. The advantages of using shape-selective columns to perform this study is demonstrated, with coupling of two CDD columns giving improved separations of these compounds. Although these compounds are relatively volatile, cryogenic modulated comprehensive two-dimensional GC was shown to provide good pulsed peak profiles with chiral separation in the first dimension when a thicker film trapping column segment was employed. The components of interest were well separated from other wine matrix components.     

The Adsorption of NOx on Magnesium Aluminium Hydrotalcite

Magnesium aluminium hydrotalcite (Mg-Al-HT) with molar ratio of Mg-to-Al of 3 to 1 was prepared and characterized by X-ray diffraction (XRD) and infrared spectra (IR). The performances of Mg-Al-HT for the adsorption and desorption of NOx were studied. The results indicated that the adsorption capacity of the hydrotalcite for NOx was 1398.2mg/g, and it was higher than the acticarbon‘s. The adsorption capacities depended on adsorption time and temperature.Mg-Al-HT could be regenerated by thermal decomposition, and the adsorption efficiency had not changed markedly after three cycles.     

Study on the anodic reaction of Ni in an alkaline solution by transient pH detection based on scanning electrochemical microscopy (SECM)

The anodic reaction of Ni in an alkaline solution was studied by the tip–substrate voltammetry mode of scanning electrochemical microscopy (SECM) and cyclic voltammetry (CV). A platinum microdisc electrode was selected as the tip electrode, which functioned as a pH sensor with transient response capability. The pH value of the solution near the Ni electrode surface varied while the Ni substrate oxidation reaction occurred, and the pH variation could be detected by the tip faradic current. The cyclic voltammogram results showed that two types of hydroxides: i.e. α‐Ni(OH)₂ and β‐Ni(OH)₂ were formed during Ni oxidation in the lower potential region. In the proceedings of α‐Ni(OH)₂ → γ‐NiOOH and β‐Ni(OH)₂ → β‐NiOOH, the process of OH^? concentration decrease in the solution was ahead and behind of electron transfer in the solid phase, respectively. These results indicate that the OH^? adsorption process occurs as an elementary step in the former reaction and the H⁺ diffusion process from the inner to the outer layer of the solid phase occurs as a subsequent step in the latter reaction. The results also revealed that the oxide film on the Ni surface has a two‐layer structure. The real potential of the oxygen evolution reaction (OER) on the Ni surface with different cycles is also analyzed in the paper. Copyright © 2007 John Wiley & Sons, Ltd.     

液膜法分离钒(Ⅳ)的研究

本文用P204-兰113A-煤油组成的滤膜体系处理钒(Ⅳ)的溶液,并考察了表面活性剂、载体、外相pH值、内相酸度、起始钒(Ⅳ)浓度以及乳水比等因素对分离的影响。     

Zr（Ⅳ）／PVA功能膜的膜催化酯化反应研究

在催化与渗透汽化分离技术相偶合的渗透汽化型膜反应器中，研究了羧酸酯的液相合成反应．实验中制备了两类具有强酸催化活性的ｚｒ（Ⅳ）／ＰＶＡ（聚乙烯醇）功能膜，采用管式膜方式，以乙酸正丁酯的合成反应为探针，对这类新型的催化反应技术在催化活性、分离性能以及分离对反应转化的影响等方面进行了探索性研究。从得到的结果看，膜催化酯化反应过程的反应条件和缓，转化率可达到９８％，反应的选择性为１００％．     

某些分子光谱分析法测定核酸的进展

对近年来利用分光光度法、荧光法和共振光散射法定量测定核酸的现状进行了评述，表中列出了重要的反应体系及分析特征，引用文献77篇。     

Soluble polymer bound cleavage reagents: a multipolymer strategy for the cleavage of tertiary amines from REM resin

Soluble polymer bound reagent 1 has been prepared to cleave tertiary amines from REM resin. Normally, amines cleaved from REM resin require extraction or chromatography to remove excess cleavage reagent and its byproducts. The solubility profile of non-crosslinked polystyrene (NCPS) based reagent 1 eliminates the need for such purification and allows for the direct isolation of a library of pure tertiary amines through simple filtration and concentration operations.     

LBL分子沉积法制备葡萄糖氧化酶电极

采用以静电力为主的逐层分子交替沉积技术制备葡萄糖氧化酶（GOD）电极.通过带有正电荷的聚二甲基二烯丙基铵盐酸盐（PDDA）和带有负电荷的GOD交替沉积在修饰有3-巯基-1-丙基磺酸钠（MPS）的金电极表面.以甲酸二茂铁为电子媒介体,用循环伏安法检测GOD电极对葡萄糖的响应.结果表明,当GOD电极组装层数小于4时,电流响应随着层数的增加而增大,超过4层时电流响应减小.其中4层GOD修饰电极的线性范围为0.55～6.63 mmol•L－1,当pH为7.0时,响应最大.同时电极的检测重现性能良好,相对标准偏差为2.4％.     

Potential energy surfaces for HenNe+ ions: ab initio and diatomics-in-molecule results

The potential energy surface of He2Ne+ has been reinvestigated using a combination of ab initio and diatomics-in-molecule (DIM) calculations. In contrast to the reports of two recent studies the ion is found to have an asymmetric linear He-Ne-He structure, with no barrier to formation from the separated atoms on the ground-state surface. The He-Ne+ bond lengths at the potential minimum are 1.51 and 1.81 A, and the total bonding energy is 0.717 eV. Comparing the He2Ne+ energy to that of HeNe+, the bonding energy for the second helium atom is 0.06 eV, about 10% of that of the first He atom. The saddle point between the two equivalent minima is a symmetric structure, 0.0074 eV above the potential minimum. A symmetric geometry becomes the overall potential minimum if the 2s hole on the Ne is excluded from the reference states of a multireference configuration interaction calculation. A DIM potential was created for the HenNe+ family of ions. The DIM potential is consistent with the asymmetric He2Ne+ ion serving as a core; it predicts a slightly more asymmetric geometry than the ab initio results. Additional helium atoms form five-membered rings around the bonds of the core ion to fill the first shell and then add to the ends of the cluster. The asymmetric core ion and the highly compact structure help to account for the lack of apparent shell structure in the mass spectrometry of HenNe+ clusters. Finally, we recommend that the value De=0.63+/-0.04 eV be adopted for the ground state of HeNe+.     

Cure reaction and phase behavior of liquid crystalline epoxides-anhydride systems

A series of novel liquid crystalline epoxides with lateral substituents were cured with anhydrides and the cure kinetics was investigated by non-isothermal DSC technique. The results showed that the lengths of lateral substituents have great effect on the value of Ea. The curing reaction became less active, when the liquid crystalline epoxides have long lateral substituents and were controlled by diffusion at the late stage of cure. A nematic structure was observed by POM and XRD.